Scoop a pea-sized amount of wood putty onto your putty knife, or more if the hole is large. Press the putty into the drill hole, forcing as much into the hole as possible. Use your finger to slide excess putty from around the hole into the hole area, smoothing the puttied hole surface as you work.


Can I drill into MDF? MDF panels hold screws as well as most natural woods, but drill a pilot hole first. You also can join this wood composite with spiral grooved dowels, coated staples, and ring shank nails. Athough most home centers now carry MDF, it is often called by other names, such as Medite or furniture-board.

how do you drill holes in laminate cabinets?

Place the tip of the drill bit on the center mark and hold the drill so the bit is perpendicular to the laminate surface. Apply light pressure to the drill so the bit presses into the masking tape, and then squeeze the trigger. Allow the drill to do the work and bite into the laminate.

How do you repair laminate cabinets? Push the laminate into the glue, and apply a heavy-duty masking tape to the repair. Wrap this around the door to the opposite side and secure it in place. You may need to use more than one layer of tape to hold the laminate down until the adhesive dries.

can you drill through laminate flooring?

Drilling plastic laminate is not that much different than drilling into wood. Though the surface of laminate is indeed hard and durable, it drills easily with a sharp wood drill bit. There are, however, a few steps you can take to make the job easier. A new, sharp drill bit will insure a clean hole.

How do you repair a hole in laminate flooring? Repair holes with putty and laminate repair paste that is sold at your local home and garden store. Clean the hole and the area around it with a dry washcloth. Apply laminate repair paste, sometimes known as laminate filler, into the hole you are trying to fill.

how do you fix peeling laminate cabinet doors?

How to Fix a Peeling Laminate Cabinet Door

How do you fill screw holes in wood cabinets? For a hole less than ½ inch in diameter, use toothpicks to fill the hole. Dip the broad ends of the wooden toothpicks in the wood filler, and insert them into the hole. Add toothpicks until the hole is completely filled to its edges. Use more toothpicks between toothpicks, so that there aren't any gaps.

How do you drill through melamine without chipping?

A sharp brad-point bit will make a clean hole, but the melamine is hard on the cutting edges and a typical bit will quickly dull. Production shops use special carbide-tipped bits that are expensive and hard to find. For the weekend builder, the best way to drill holes in melamine is to use a router.

How do you fill a wood hole in a door frame? Fill the hole with a non-shrinking wood filler or a paintable new wood epoxy. Either process will fill the hole and allow you to redrill or cut in the general vicinity if you so desire. Remove the door strike and any hardware from the area. Sand the edges of the opening to remove splinters.

How do you fix a cabinet?

Start by removing the hardware. Then apply a drop of wood glue to the ends of toothpicks and cram as many as will fit into the hole (maybe only two or three). Wipe away any glue that drips out. Let the glue dry, then use a utility knife to cut the toothpicks flush with the cabinet or drawer.

How do you fill in old hinges?

How to Fill an Old Door Hinge Position Step 1 - Fill in the Hole. Before you can fit any covers over the holes, you will first need to add some caulking to the wood, in order to prevent the wood splitting during temperature changes. Step 2 - Fit the Wood. Step 3 - Finishing Up.